4. 9. 2014

The NetFPGA-1G-CML is a versatile, low cost network hardware development platform featuring a Xilinx Kintex®-7 XC7K325T FPGA and includes four Ethernet interfaces capable of negotiating up to 1 GB/s connections. 512 MB of 800 MHz DDR3 can support high-throughput packet buffering while 4.5 MB of QDRII+ can maintain low-latency access to high demand data, like routing tables. Rapid boot configuration is supported by a 128 MB BPI Flash, which is also available for non-volatile storage applications. The standard PCIe form factor supports high speed x4 Gen 2 interfacing. The FMC carrier connector provides a convenient expansion interface for extending card functionality via Select I/O and GTX serial interfaces. The FMC connector can support SATA-II data rates for network storage applications. The FMC connector can also be used to extend functionality via a wide variety of other cards designed for communication, measurement, and control. 

 NetFPGA-1G-CML

  • Xilinx Kintex®-7 XC7K325T-1FFG676 FPGA
  • Low-jitter 200 MHz oscillator
  • Four 10/100/1000 Ethernet PHYs with RGMII
  • X4 Gen 2 PCI Express
  • X16 4.5 MB QDRII+ static RAM (450 MHz)
  • X8 512 MB DDR3 dynamic RAM (800 MHz)
  • 1-Gbit BPI Flash
  • SD card slot
  • 32-bit PIC microcontroller
  • USB microcontroller
  • Real time clock
  • Crypto-authentication chip
  • High pin count FMC connector (VITA 57) with 100 Select-IO and 4 GTX serial pairs
  • Two Pmod™ connectors
  • Four on-board LEDs and four onboard general-purpose buttons

The NetFPGA-1G-CML is designed to support the Stanford NetFPGA architecture with reference designs available through the NetFPGA GitHub Organization (http://www.github.com/cmlab/netfpga-1g-cml/wiki). It is fully compatible with Xilinx Vivado and ISE Design Suites as well as the Xilinx SDK for embedded software design.