Overview

The Trenz Electronic TE0701 carrier board provides low-cost connection and extension to the Trenz Electronic TE07xx series.

Features

• Trenz 4x5 Module Socket (3x Samtec connectors)
• RJ45 GbE Ethernet
• MicroUSB Connector (Device, Host or OTG Modes)
• SD Card connector - Zynq SDIO0 Bootable SD port
• Pmod Connector A, 3.3V
  • 6 Pins can be multiplexed to SD Card pins (MIO1 bank when using TE0720)
  • 2 Pins connected to Carrier Controller CPLD
• Pmod Connector B, 3.3V
  • mapped to 8 PS MIO0 pins if using TE0720 (same mapping as on zedboard)
  • 6 Pins also connected to Carrier Controller CPLD
• Single 12V Power supply
• High Performance Enpirion DCDC converter for local supplies
• VITA57.1 compliant FMC LPC Connector
  • Digitally programmable FMC VADJ Power Supply
• Carrier Controller CPLD
  • 1200 Macrocell CPLD with Block RAM, Flash and PLL
  • 8 User LEDs mappable to different functions
  • 2 User Pushbuttons mappable to different functions
  • VID and EN control for FMC VADJ DCDC Regulator
• USB JTAG Interface
• mini USB connector
• Compatible with Xilinx tools: Impact, Chipscope, XMD, Vivado/SDK etc..
• Compatible with OpenOCD debugger including ZYNQ SRST control
• Based on FT2232H USB chip
• Channel A can toggle Module (ZYNQ PS) Reset
• Channel B can be used as USB UART
  •  Carrier Controller can reroute RXD/TXD signals
• JTAG Port can be connected to (by the Carrier Controller)
• 4x5 Module JTAG (FPGA + ARM chained in Zynq)
• 4x5 Module JTAG and FMC JTAG in chain
• FMC JTAG alone
• Zynq ARM PS JTAG port (via EMIO muxing in TE0720)
• 6 Pin header for off board use
• Pmod Connector B for off-board use